CGV Ventanas

Step-by-step directions for gluing inner corners

When completing, the principal problem can be irregular walls and the consequent springs on the background. It is also essential to take into account that when the walls are twisted the joints of background canvases might invisibly.

After gluing the previous one in the front of the interior corner of the cloth must measure the remaining distance. It is measured from the edge of the pasted cloth to the adjoining wall, the resulting figure is added 10-15 millimeters. If the walls are very curved, then the further figure may be .

Cut a strip equal to the resultant figure, taking into account the allowance. The surfaces are treated with glue. Based on the type of coating it could be only the wall or surfaces gidpola.ru.

The strip is then glued individually with the cut side to the wall. The wallpaper should go on the opposite plane.

If the glued wallpaper is sterile, then you have to make a few small cuts perpendicular to the springs.

Level or slope on the adjacent wall is a perpendicular lineup. The distance from the corner is equivalent to the width of the prior cut strip, never such as developments.

The surfaces have been smeared with glue, and then the coat is glued to the wall with the flat side towards the line. The cut side goes onto the adjacent wall.

Protruding corner should be glued by analogy with the inner, however there are small differences, which also have to be taken into account when working.

Measured the distance remaining from the glued background into the adjacent wall. Add 20-25 millimeters to the obtained figure.

A segment is cut away, taking into account the additional 20-25 millimeters.

Before gluing, the surfaces have been treated with adhesive.

The edge has to be glued into the background fixed on the walls, the own cut facet»extends» to the next plane. If necessary, small cuts are made in the place of visiting another wallpaper, smoothed and pushed to the wallsocket.

Draw a vertical strip onto the adjoining wall at a distance of only glued cut strip and 6-10 millimeters.

After applying the adhesive, the strip is then applied to the wall using its flat side towards the marked line, going over the border of the glued strip.

The joints have been smeared with glue and ironed with a rollercoaster. After that, the upper layer is cut across the ruler and the two layers are joined together.